Product Sheet

Download PDF



  • Square luminaire for installation in wall and ground - recessed.
  • Configuration: die-cast aluminium structure, EN AB-47100 alloy (low copper content). Glass diffuser fixed to the aluminium body through a robotic gluing system.
  • Double layer coating for high resistance to corrosion: the aluminium components are painted with a double coat using powders which are compliant with QUALICOAT standards: a first layer of epoxy powder (with excellent chemical and mechanical resistance) and a second finishing layer of polyester powder (resistant to UV rays and atmospheric agents). The entire painting process of the aluminium fitting starts from components which have been sandblasted in advance to make the surface more porous and increase the adherence of the paint. Ares effects alkaline and acid washing to clean the surfaces completely, then rinses with demineralised water to remove any residue particles, subsequently a chemical conversion treatment is done to protect against rusting.
  • Protection rating: IP67
  • In compliance with EN 60598-1 standards
  • Class of insulation: III
  • Installation: the luminaire is equipped with 300mm of cable for a quick connection. K12 Power LED is equipped with a dc/dc highly efficient converter that removes electromagnetic interference and allows parallel wiring. The whole range is protected against polarity reversal and sudden voltage peak. Outdoor use requires suitable flexible cables. Installation requires a dedicated box to be ordered separately. It is important to provide a >200mm gravel layer or a drain system (for concrete surface) to ensure good drainage and to avoid water stagnation.
  • We recommend the use of a connection system with a protection degree greater than or equal to the protection degree of the luminaire.
Ground Recessed
Wall Recessed
K12ln RGB Low Power LED / Diffused light

Light Flux
Product Code Details
Light Source
Total power 8W
Remote electronic power supply to be ordered


Photometry Image not Available IES/LDT Photometries not Available
Installation Data Sheets (of the product and of its accessories) ARES_K12_manual.pdf

Download Technical Drawing: k12ln.dwg


Code: 183

Box for installation

322 x 70 x H 95 mm

Code: 153

Suction cup to pull the luminaire

Code: 148

Supported n. of lamps: 5
Power supply with DMX interface for RGB fixtures

(3CHx18W) DMX controller allowed

Code: 142

DMX Controller

Dimmer switch for recessed box (60 mm hole centres)

Code: 143

DMX Controller

Stand-alone/PC interface

Code: 186

DMX cable

Shielded twisted pair with 110 Ohm constant impedance

Code: 187

DMX splitter

Eelectronic device to regenerate the DMX signal.
1 input and 7 output. 12÷24Vdc
Power supply to be ordered (87 or 175 recommended)