Product Sheet

Download PDF

10017412

Tapioca

  • Square or round luminaire - for installation in wall, ceiling or ground - recessed.
  • Configuration: die-cast aluminium structure, EN AB-47100 alloy (low copper content). Anodized aluminium frame - only round. Glass diffuser: transparent or sandblasted, fixed to the aluminium body through a robotic gluing system.
  • Double layer coating for high resistance to corrosion: the aluminium components are painted with a double coat using powders which are compliant with QUALICOAT standards: a first layer of epoxy powder (with excellent chemical and mechanical resistance) and a second finishing layer of polyester powder (resistant to UV rays and atmospheric agents). The entire painting process of the aluminium fitting starts from components which have been sandblasted in advance to make the surface more porous and increase the adherence of the paint. Ares effects alkaline and acid washing to clean the surfaces completely, then rinses with demineralised water to remove any residue particles, subsequently a chemical conversion treatment is done to protect against rusting.
  • Protection rating: IP67
  • In compliance with EN 60598-1 standards
  • Class of insulation: III
  • Installation: the luminaire is equipped with a piece of cable for an easy-to-make connection and an H2O STOP device. Tapioca 24V is equipped with a dc/dc highly efficient resin-coated converter that removes electromagnetic interference and allows parallel wiring. The luminaire is protected against polarity reversal and sudden voltage peak. Installation requires a dedicated box to be ordered separately. It is important to provide a >200mm gravel layer or a drain system (for concrete surface) to ensure good drainage and to avoid water stagnation.
  • We recommend the use of a connection system with a protection degree greater than or equal to the protection degree of the luminaire
Warnings
Ground Recessed
Wall Recessed
Ceiling Recessed
Tapioca RGB Power LED / Ø 70mm - Transparent Glass - Narrow Beam 10°

Light Flux
Placement
Product Code Details
10017412
Light Source
RGB POWER LED 3,4W/3CHx350mA
Total power 3,4W
Remote electronic power supply to be ordered
 

Download ENERGY LABEL

Photometry Image not Available IES/LDT Photometries not Available
Installation Data Sheets (of the product and of its accessories) ARES_Tapioca_manual.pdf

Download Technical Drawing: tapioca-round-d70.dwg

Accessories

Code: 101

Box for installation

Ø 130 H 110 mm

Code: 141

Supported n. of lamps: 10
Power supply with DMX interface for RGB fixtures

36W/220÷240V-3CHx350mA
(3CHx10x1W) DMX control allowed
IP67 CLASS I SELV EQ.

Code: 142

DMX Controller

Dimmer switch for recessed box (60 mm hole centres)

Code: 143

DMX Controller

Stand-alone/PC interface

Code: 187

DMX splitter

Eelectronic device to regenerate the DMX signal.
1 input and 7 output. 12÷24Vdc
Power supply to be ordered (87 or 175 recommended)

Code: 186

DMX cable

Shielded twisted pair with 110 Ohm constant impedance